Samsung Galaxy A3 (2017) FRP Bypass Guide: Remove Google Account Lock

Initial Steps: Hard Reset

• 📱 First, shut down the Samsung Galaxy A3 (2017). If a lock screen password is required, use the button combination: power and volume down until the screen turns off, then immediately switch to power, volume up, and home button. Release power when the Samsung logo appears, holding volume up and home until the Android logo shows.
• 💡 If the phone powers off normally, wait 5 seconds after shutdown, then press and hold power, volume up, and home. Release power on the Samsung logo, holding volume up and home.
• ⚠️ When the 'No command' screen appears, press and hold power, then briefly press volume up to access recovery mode.
• ✅ Navigate to wipe data/factory reset using volume keys and confirm with the power button. Select 'yes' to confirm the reset.
• 🚀 After the reset, select reboot system now to restart the phone.

Preparing for FRP Bypass

• 💻 For the FRP bypass, a computer is required. Visit hardreset.info to download necessary files for free.
• 🔍 On the website, search for 'Samsung Galaxy A3 2017' and navigate to the combination firmware section.
• 📌 Note the firmware version displayed on your phone (e.g., A320L XXS9). Find the corresponding combination firmware on the website (e.g., U9 for S9).
• 🔄 It's recommended to set the phone's language to English (United States) for compatibility during the process.
• ⚠️ After initial setup, check if the FRP lock is still present. If not, the rest of the video may not be needed.

Downloading and Flashing Combination Firmware

• 📂 Download the appropriate combination firmware for your device model from hardreset.info.
• 🛠️ Download Samsung USB drivers, mini ADB and fastboot drivers, and Odin (version 3.14.4 or newer) from the website.
• 📦 Extract all downloaded archive files using a program like WinRAR.
• 🔌 Shut down the phone and boot into download mode by holding power, volume down, and home buttons until a warning screen appears, then press volume up.
• 💻 Connect the phone to the computer via USB cable.
• 🖱️ Open Odin, click on AP, and select the extracted combination firmware file.
• ▶️ Click Start in Odin to flash the combination firmware. This process takes about a minute.

Enabling Developer Options and Flashing Stock Firmware

• 💡 After flashing, the phone will boot into a special system. Navigate to Settings > About phone, then tap Build number seven times to enable Developer Options.
• ⚙️ In Developer Options, ensure USB debugging is enabled.
• 🔌 Turn off the phone and boot back into download mode.
• 🖱️ In Odin, click Reset and load the stock firmware files: BL, AP, CP, and Home CSC (ensure it's 'Home CSC', not just 'CSC').
• ▶️ Click Start in Odin to flash the stock firmware. This process takes longer, around 2-3 minutes.

Final Steps and Reset

• ✅ Once Odin shows 'Pass', unplug the phone and wait for it to restart. It will install system updates.
• 🔓 If the phone boots to the home screen without a Google lock, the bypass is successful. If not, use the unlock FRP app (downloaded from hardreset.info) by connecting the phone and clicking 'unlock'.
• 🔄 For a clean setup, perform a final factory reset through the phone's settings: General settings > Reset > Factory settings > Reset > Delete everything.
• ✨ The phone will restart without any FRP lock, allowing you to set it up as new.