Miniature Wingback Chair & Ottoman | DIY 1:16 Scale

Constructing the Miniature Chair Frame

• 💡 The project involves creating a miniature wingback chair and ottoman in 1:16 scale for Aunt Clara's dollhouse.
• 🛠️ The base structure is built by cutting and gluing eight layers of cardstock or food packaging to achieve an eighth-inch thickness.
• 📐 Wing sections and the back piece are gently curved outward and backward, respectively, and then sanded to soften hard edges.
• ✅ The back is glued to the side pieces, ensuring flush edges for a clean fit, with the chair bottom and armrests added sequentially.

Padding and Fabric Application

• 🧵 Armrests are formed by rolling two and a half strips of pattern pieces and are then glued to ensure even overhang.
• ☁️ The chair wings are padded with felt or batting, with an additional layer for extra fluffiness, and then covered with lightweight fabric.
• ✂️ Fabric is carefully trimmed and notched around curves to ensure a smooth, flat finish, with special attention to covering armrest backs and extending fabric past padding.
• ⚠️ A tacky glue stick is used for fabric, with a warning to avoid getting it on outside fabric as it's difficult to remove.

Detailing and Finishing Touches

• 🛋️ Inner chair and armrest pieces are dry-fitted and adjusted before being glued onto felt and fabric, with raw edges folded and secured.
• ✨ The inside back is made with three layers of batting for a soft look, and a small foam board strip is added to give the back a slight, relaxed tilt.
• 🪑 Cushions are constructed from foam board, covered with batting and fabric, and given a finished edge with a fabric-covered cardstock strip.
• 👣 Chair feet are made from eight layers of cardstock with toothpicks for attachment, and piping is created using crochet thread and fabric for decorative edges.
• 🎁 A matching ottoman is built with a layered cardstock base and a cushioned top, completing Aunt Clara's cozy miniature set.